Wenesco High Temperature Pumps
top of page

Wenesco High-Temperature Pumps

 

For any questions regarding our High-Temperature Pumps, please reach out to Enver Poljak, at Enver@wenesco.com.

​

Wenesco High-temperature Pumps are used for transferring molten salt, zinc, lead, and other non-viscous material at 700C.

These centrifugal pumps, with no seals, require only minimal maintenance. They are available with electric or air motors.

WENESCO HTP1 with 1-HP motor
WENESCO PUMP CHART 1

TUBE FRAME PUMPS

  • Select 120 or 240V for electric motor

  • Select 304 stainless steel or cast iron construction

  • Starter with thermal protection

  • Discharge: 1.25 NPT

  • Complete air control for air motor

  • 316 SS construction optional at additional cost

  • Gussets for lowering pump during operation

  • VFD Speed control optional at additional cost

WENESCO Model HTP1 with air motor
WENESCO PUMP CHART 2
WENESCO Model HTP2 with 2-HP motor
WENESCO PUMP DIMENSION DIAGRAM EXAMPLE
Molten Salt Pumps
CUSTOM MOLTEN SALT PUMP
CUSTOM MELTER DIAGRAM EXAMPLE WENESCO
CUSTOM MELTER FOR MOLTEN SALT

(Above) Molten Salt Pump custom made for mounting in our customer’s tank

WENESCO PUMP LOOP DIAGRAM EXAMPLE

(Above) This temperature-controlled heated tank, combined with a high temperature pump
delivers molten salt, used as a coolant. to a Molten Salt Reactor.

The 316-stainless steel reservoir holds 7-1/2 gallons (120 lb. salt) and will operate up to 700C.
Temperature is controlled with an accurate digital thermostat, while pump speed and flow
are controlled with a Variable Frequency Drive. 

 

Power: 13,800 Watts, 240V single or three-phase.

(To The Left) Molten Salt Loop Test System

(Below) This pump for molten salt features an immersion depth of 144 inches. It is made from 316 stainless steel. This pump includes a 3-in NPT discharge pipe. The 5-HP air motor delivers ample power to pump 180 GPM @ 15 ft. head.

WENESCO SALT PUMP SCHEMATIC
LARGE WENESCO CUSTOM MOLTEN SALT PUMP
H-Frame Pumps

(Below) For Zinc, Lead, & Other Soft Metals

H-frame pumps for Zinc and Lead are made to order.

  • STYLE HS has 54 inch maximum immersion.

  • STYLE HL has 81 inch maximum immersion

  • Electric or air motors up to 25 HP

  • Explosion-proof motors. (Class 1,Div 2) is optional

  • Cast iron volute and impeller

  • 304 Stainless steel shaft and frame

  • Heavy duty hooks mounted to frame to raise and lower the pump.

CUSTOM SPINE FRAME PUMP WENESCO
WENESCO H FRAME pump
H-Frame Pumps

(Below) Suitable for shorter immersion depths with a wide selection of motors.

WENESCO HTP8030

Click HERE to head back to the Homepage and learn more about our full line of Industrial Heating Equipment

bottom of page